BOGE Stainless Steel 510 RBN BDC Cartomizer is an updated model from 510 cartomizers. The heating coil is revised to be bottom dual coils design. Pre-Punched Low resistance cartomizers 1.8 - 2.0 ohm. Cartomizers have been "Pre-Punched" with (4) Holes for use in Cartomizer tanks. Note: these are for standard length (35mm) tanks, not the longer "DCT" tanks. Please check tank length prior to order.
1. Bottom dual coil
2. Low resistance: 1.8-2.0 ohm
3. 4 holes prepunched on the bottom
4. Stainless steel body
510 Battery Connection, 9.2mm diameter, standard length (35mm, 40mm overall)
fits chrome and plastic 510 drip tips (sold separately)
Price is for pack of 5 Cartomizers.
These cartomizers are empty (blank) so that you may fill with your choice of e-liquid. Soft rubber easily removable end caps on these cartomizers make filling with e-liquid a breeze. You may also use a 510 size drip tip to replace the rubber end cap. Be careful to drip the e-liquid around the sides, avoiding the center hole. Each cartomizer can be re-filled several times before discarding. It is recommended to use 20 to 30 drops of e-liquid for the first filling. As the cartomizer starts to produce less vapor, add between 5 to 10 drops of e-liquid. Allow the cartomizer to sit upright for a few minutes during the first filling to allow liquid to soak down through the absorbent filler material. Please note: the heating coil located at the bottom of the cartomizer needs to be wet with e-liquid before use. "Dry Firing" the cartomizer may burn up the heating coil.
Please note: There is no warranty, returns, refunds or exchanges on cartomizers.